Share your CCIE v5 Written Experience
Please share with us your experience after taking the CCIE v5 Written exam, your materials, the way you learned, your recommendations… But please DO NOT share any information about the detail of the exam or your personal information, your score, exam date and location, your email…
Note: There are some guys trying to sell workbook, videos or even group buy for CCIE exams in the comment section. Please be careful and double check everything before making your decision. Many of them are scammers and just sell old materials or steal your money.

Passed today. Used PassLeader 195Q+208Q. About 90% of questions from the PL 400-101 dump.
Some corrections I had found to the dump while studying, NOT 100% CORRECT, JUST FYI:
13: C – 802.15.1 is bluetooth and the question asks what is “predominantly”……
31: Correct answer is none of these. I believe B) should be 2001:12:1/128, which would be correct.
71: D&D I believe ETR should be “Receives packets from the core network” and “Routes traffic to remote LISP sites”.
93: B, E, F – Not too sure about this one
97: Their answer is D & E, but D is not correct. It probably should say something like “ISATAP only transfer unicast……”
124: A, B, F – Again, not too sure about this one.
132: This questions was on the test, but it was slightly different. . . was a choose 2 out of 6 options, and the missing option has the static 1:1 nat entries with the correct inside/outside. Is this question is written, B&C appear to be correct, except the “netwmask” typo in B. E has the wrong inside/outside assignments.
137: flow policy, flow monitor, service policy, class, flow exporter, flow record.
140: 2:1 4:2 1:3 3:4
……
Good luck, all!
dear Kevin Claxton
can you send me the pdf of dump please !
Hello guys, Could you please share the 195q dump please?
Yes, please share Q195 or give hint where to get it.
Which answer is correct? thanks
which two statements about Management Plane protection are true?
A. it can handle management traffic when IP Cisco Express Forwarding is disabled.
B. it supports in-band and out-of-band management interfaces.
C. it is enabled by default, but it allows all management protocols to pass freely throug all interfaces until it is conifgured.
D. it supports the SNMP, SSH, TFTO and HTTP management protocols.
E. it provides granular control over the management protocols that are allowed on an interface
Which answer is correct? thanks
which options lists the cloud service models?
A. Infrastructure as a service, Platform as a service, and storage and storage as a service
B. Infrastructure as a service, Platform as a service, and storage and software as a service
C. Internet as a service, Platform as a service, and storage as a service
D. Internet as a service, Platform as a service, and storage as a service.
E. Internet as a service, Platform as a service, and software as as service.
@SN
what is a major disadvantage of virtual machines versus containers?
dumps – Operational Management
Me – Security (Agree)
https://www.backblaze.com/blog/vm-vs-containers/ (Less secure, at the bottom of the page)
Which router on an IS-IS network generates the IS-IS pseudonode?
dumps – Level 1 / Level 2
ME – DIS (Yes DIS)
https://www.cisco.com/c/en/us/support/docs/ip/integrated-intermediate-system-to-intermediate-system-is-is/49627-DIS-LSP-1.html#whatisdis
@IE Dreamer
which two statements about Management Plane protection are true?
B. it supports in-band and out-of-band management interfaces.
D. it supports the SNMP, SSH, TFTP and HTTP management protocols.
https://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r4-1/security/configuration/guide/syssec_cg41crs_chapter7.html#con_1007602
which options lists the cloud service models?
B. Infrastructure as a service, Platform as a service, and storage and software as a service
(This is the closest, but there isn’t a thing as Storage as a Service only Software as a Service – IaaS, PaaS and SaaS)
Can someone please confirm that the 195Q and the 208Q is still valid?
No Spammers please!!!
232q is the latest one
Updated on 10th september
Check it on certknowledge forum , its freely available.
Dumps of passwriten (208q, 232q…) contain incorrect answers. Regarding the relevance of questions, there is no information.
I believe the questions are updated and what you said about answers being wrong can be true for any dump we encounter on the web.
So for that we need to have a discussion on such questions and correct the answer.
@Anonymous
Certknowledge doesnt open at all.
PL was updated on 12 September adn they have fixed alot of wrong answers.
i think below is the correct sequence of D&D
set next hop
set interface
set default next hop
set default interface
the one the the dumps are incorrect .. can anybody confirm?
@harry
“Certknowledge doesnt open at all.” — what do you mean ? I can open the site
12 September update i havent seen – you bought it ?
@Anonymous
Yes I have it, it was updated Wednesday.
@SN – correct, in the latest dump it is like this.
set next hop
set interface
set default next hop
set default interface
Can any one confirm if the 232 q is valid and when have you passed ?
@SN is correct. Reference:
https://www.cisco.com/c/en/us/td/docs/ios/12_2/qos/configuration/guide/fqos_c/qcfpbr.html
“The set commands can be used in conjunction with each other. They are evaluated in the order shown in Step 3 in the previous task table”
Can any one confirm the answer for Q16 in the 232 .
I think it is exchange as the MTU mismatch
@Harry .. I had read 208q .. most of the question are valid i.e. about 80 percent
but there are mistakes in them as well .. both in MCQs and DnD ..
can anybody confirm if below statement is correct ?
EIGRP RTO – It is six times the SRTT .. (as per dumps this is the right answer)
@SN
No, Time a packet takes to get acknowledged.
Please email me ccielabdump @ gmail.com if you want to have full pack CCIE Lab dump to practice.
(included all the 2018 CCIE R&S Question Paper, Answers and EVE simulator to practice the exactly the same lab exam)
@Harry @SN
imho, I believe the correct answer for the D&D you mentioned is below:
set interface
set ip next-hop
set default interface
set ip default next-hop
see page 17-2 in below article for reference:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/5_x/nx-os/unicast/configuration/guide/l3_cli_nxos/l3_pbr.pdf
do you agree?
@anna,
In book: Implementing Cisco IP. Routing (ROUTE). Foundation Learning Guide. Foundation learning for the. ROUTE 642-902 Exam, 2010, page 449, indicates the following:
“The router evaluates the first four set commands for PBR shown in this section in the order they are presented.”
set ip next-hop
set interface
set ip default next-hop
set default interface
@4han
Dead R 40 C 40, Hello R 10 C 10
R = Received, C = Configured
Mask R 255.255.255.248 C 255.255.255.240
they are different subnets
Thank you for the info and reference @kivito
@4han
Can any one confirm the answer for Q16 in the 232 .
I think it is exchange as the MTU mismatch
Just labbed this and I’m stuck in exstart/exchange. I set MTU 1500 and other side 1530.
Neighbor ID Pri State Dead Time Address Interface
3.3.3.3 1 EXSTART/DR 00:00:36 30.30.30.1 GigabitEthernet0/0
After a minute;
*Sep 16 09:57:24.452: %OSPF-5-ADJCHG: Process 1, Nbr 3.3.3.3 on GigabitEthernet0/0 from EXSTART to DOWN, Neighbor Down: Too many retransmissions
Anyone know the answer to qu. 235 in latest passwritten dump?
The answer is blank in the dump.
“Refer the exhibit. Which two statements correctly describe the final state of the routing table if the R1 IS-type is changed to level 1 only?”
Thanks!
Who all are preparing to book the exam this week? I am planning for this week .
Could you please confirm if Passleader 195 + 208 Q&As is still valid?
Anyone kindly share the latest PassLeader 400-101 dumps with 195q+208q???
Thanks
in
advance!!!
Thanks
in
advance!!!
Thanks
in
advance!!!
anyone have idea about which dump is valid please?
i should take the exam tomorrow.
Pass the exam today. Sep 17th.
Latest 238Q is enough.
CCIE RNS v4.0 – 400-101 – Written – 20-Sep-18
I have passed on Saturday with score 922.
Thanks to everyone in the forum for their support.
around 85% of the questions were from 208q. But as i have mentioned earlier that there are couple of mistakes in 208q. Both in MCQs and DnD so please verify them.
I had purchased the dumps as my exams were expiring in a short time. The purchased dump had 270q.
@SN, May i know the vendor where you purchased?
Hello Lads,
A quick question on Question 102:
I think it is B and D not C and D what do you think. The Switch or an AP does not cache usernames and passwords.
cheers
@Shan S P O T O
guys, i can confirm 238 is valid. some are wrong so you have to figure them out but hurry up.i just passed.
http://www.certknowledge.com/forum/topic/71281-ccie-rns-v50-400-101-written-15-sep-18/
Yes 238q from certknowledge can be used to pass.
thanks to OP for sharing it.
can some please help me with cisco iou setup
In which two modes do IPv6-in-IPv4 tunnels operate? (Choose two.)
A. tunnel mode
B. transport mode
C. 6to4 mode
D. 4to6 mode
E. ISATAP mode
195q and 208q have conflicting answers. AB and CE.
@Louie it must be C and D
As L1 router has only intra area LSA
https://www.cisco.com/c/en/us/support/docs/ip/integrated-intermediate-system-to-intermediate-system-is-is/200293-IS-IS-Adjacency-and-Area-Types.html
Guys what about 176:
I think it is A, E, F: For example A -> Server, E -> Client PC, F -> A switch or an AP which relays the credential. What do you think ?
One more:
192: A and F -> There are three types of messages not sure if this refers to Queries.
What do you think ?
what happens with Certcollections guys?
Now everyone is going to certknowledge forum
certcollection got closed i think
@Dallas
In which two modes do IPv6-in-IPv4 tunnels operate? (Choose two.)
A. tunnel mode
B. transport mode
C. 6to4 mode <<
D. 4to6 mode
E. ISATAP mode <<
thanks @Harry
Anyone passed exam today?
I have my exam tomorrow
Those who wrote exam, can you remember D and D you got?